[ICOM] IC-765 Question

[Larry Young]

There are several questions that require an answer first. Is the built in antenna tuner turned off and in bypass mode? Is your external wattmeter that you are using for your measurements accurate thru 10 meters, and is it located at or near the RF output connector of your 765? Is the DC power supply that you are using rated for the required DC current and not going into current limit at the higher bands? Is the DC voltage supplied to the 765 actually 13.8 volts when measured at the DC input of the rig at full current load? these are all things that could affect the accuracy of RF output power.
Larry K4LXV

--- On Sun, 4/14/13, H. Dave Meitzen <dmeitzen at tx.rr.com> wrote:

From: H. Dave Meitzen <dmeitzen at tx.rr.com>
Subject: [ICOM] IC-765 Question
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Date: Sunday, April 14, 2013, 12:39 PM

160M to 40M the output is 100 watts are better. 20M and up progressively
lower output 60 watts to 40watts on 10M.

Any recommendations where to start to look?

Thanks
Dave

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html