[ICOM] For Sale: Classic ICOM gear

Edward Dickinson, III softblue at windstream.net
Thu Sep 30 18:39:27 EDT 2010


Gary - right on the UX-14.  One must manually turn down the power on
pre-IC-735 rigs(?).  One advantage to that...One can tune at low power and
bring the power up some and find a more precise tune (lower SWR) under
higher power.  I'll not attempt to quantify 'higher power', but I never had
any issues here (IC-735, 730, 740, 745, 751A). 

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Gary P. Fiber
Sent: Thursday, September 30, 2010 6:24 PM
To: ICOM Reflector
Subject: Re: [ICOM] For Sale: Classic ICOM gear

You are correct on the RC-10. The AH2A with the controller will work with
the IC-751A but you need the UX-14 installed to make it work like it does
with the IC-735.

Gary K8IZ

On 9/30/2010 3:09 PM, Edward Dickinson, III wrote:
> For Sale:
>
> IC-751A late model - PBT
> 	Optional Internal Power Supply
> 	Non-Volatile RAM Backup
> 	60 Meter enabled
> 	HM-12 Hand Mic
> 	Ceramic Trimmer Capacitors
> 	Manual, Schematics, Copy of Service Manual
> 	Cosmetic 7 - Has good repaint (was mobile at times)
> 	    - couple of touched-up scratches on top edge of Front Panel
> 	$500 + shipping
>
> AH-2a   Tuner - By itself, same electronically as AH-3
> 	Works with IC-725, 726, 728, 729, 706 and all current ICOMs with 4 
> Pin Tuner Connection
> 	Some marks on plastic tuner body
> 	SO-239 Input installed
> 	Will work with non-ICOM gear with simple tune actuation circuit 
> (resistor, diode, LED)
> 	Manual, schematics
> 	$220 + shipping
> AH-2a  Control Head
> 	Adapts IC-730, 735, 740, 745, 751/A to Tuner
> 	$60 + shipping (needs OPC-118 for those above other than 735)
> OPC-118  7 and 8 pin to 24 Pin Molex adaptor
> 	$25 mailed CONUS
> (AH-2a  Tuner, Control Head and OPC-118
> 	$250 + shipping)
>
> IC-RC10  Frequency Control Pad for IC-751/A (only, AFAIK)
> 	$50 mailed CONUS
>
> SM-8 	Desk Mic
> 	Two Cords - switchable between two rigs from mic
> 	(2nd cord/plug not ICOM original)
> 	Instruction sheet
> 	$120 + shipping
>
>
> Offered here first - to the trade boards next week Offers..?
>
> Please contact off list.
>
>
> 73,
> Dick - KA5KKT
> (Lexington, KY)
>
>
>
>
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom 
> Users Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: 
> http://www.qsl.net/icom/ To support QSL/QTH.net: 
> http://www.qsl.net/donate.html
>
>    


--
Gary P. Fiber K8IZ
Electronic Communications Systems Technician - Field General Radio Telephone
Operators License PG-19-6691,
  with Shipboard Radar Endorsement.
Washington State Resident.

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/ To
support QSL/QTH.net: http://www.qsl.net/donate.html



More information about the Icom mailing list