[ICOM] For Sale: Classic ICOM gear
Gary P. Fiber
gfiber at comcast.net
Thu Sep 30 18:23:45 EDT 2010
You are correct on the RC-10. The AH2A with the controller will work
with the IC-751A but you need the UX-14 installed to make it work like
it does with the IC-735.
Gary K8IZ
On 9/30/2010 3:09 PM, Edward Dickinson, III wrote:
> For Sale:
>
> IC-751A late model - PBT
> Optional Internal Power Supply
> Non-Volatile RAM Backup
> 60 Meter enabled
> HM-12 Hand Mic
> Ceramic Trimmer Capacitors
> Manual, Schematics, Copy of Service Manual
> Cosmetic 7 - Has good repaint (was mobile at times)
> - couple of touched-up scratches on top edge of Front Panel
> $500 + shipping
>
> AH-2a Tuner - By itself, same electronically as AH-3
> Works with IC-725, 726, 728, 729, 706 and all current ICOMs with 4
> Pin Tuner Connection
> Some marks on plastic tuner body
> SO-239 Input installed
> Will work with non-ICOM gear with simple tune actuation circuit
> (resistor, diode, LED)
> Manual, schematics
> $220 + shipping
> AH-2a Control Head
> Adapts IC-730, 735, 740, 745, 751/A to Tuner
> $60 + shipping (needs OPC-118 for those above other than 735)
> OPC-118 7 and 8 pin to 24 Pin Molex adaptor
> $25 mailed CONUS
> (AH-2a Tuner, Control Head and OPC-118
> $250 + shipping)
>
> IC-RC10 Frequency Control Pad for IC-751/A (only, AFAIK)
> $50 mailed CONUS
>
> SM-8 Desk Mic
> Two Cords - switchable between two rigs from mic
> (2nd cord/plug not ICOM original)
> Instruction sheet
> $120 + shipping
>
>
> Offered here first - to the trade boards next week
> Offers..?
>
> Please contact off list.
>
>
> 73,
> Dick - KA5KKT
> (Lexington, KY)
>
>
>
>
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>
>
--
Gary P. Fiber K8IZ
Electronic Communications Systems Technician - Field
General Radio Telephone Operators License PG-19-6691,
with Shipboard Radar Endorsement.
Washington State Resident.
More information about the Icom
mailing list