[ICOM] IC-745 Power Output

[Pete]

how does it work into a dummy load if good you have rf feedback If no no
different you probably have the typical problem of bad trim caps in the PLL
vco Pete
----- Original Message ----- 
From: "Tom Elmore" <tom at telmore.com>
To: <icom at mailman.qth.net>
Sent: Friday, April 04, 2008 7:00 PM
Subject: [ICOM] IC-745 Power Output


>   Hello, I have an IC-745 transceiver that recently developed a problem in
> the power output. I am getting about 50 watts continual RF output in any
> mode lsb,usb,cw,rtty as soon as I transmit even with the mic. gain and
power
> output pot set out at minimum. This seemed to happen after I had switch to
> and from the RTTY position. the receiver still works fine it's just RF
> output is constant.
>
>
>
>
> Thanks
> Tom / KA1NVZ
> Anchorage, Alaska
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/