[ICOM] help needed in A6 with new 7800 and PW1

[Dick Dievendorff]

Try this:
http://icomamerica.com/en/support/kb/Article.aspx?ArticleNumber=615A26584A

There's a place where you want to turn off the transceiver that isn't
immediately obvious from the PW-1 instruction manual.

Dick, K6KR


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Don Greenbaum
Sent: Wednesday, December 05, 2007 9:48 AM
To: icom at mailman.qth.net
Subject: [ICOM] help needed in A6 with new 7800 and PW1

I am currently in A6 at A61ADs setting up a new 7800 and PW1.

THe PW1 just doesn't want to follow the 7800.  I'm positive we have it 
hooked up right.  The manual says to reset the linear by holding the 
up/down buttons and then hitting the power button.

It doesn't appear to do anything.

AND, if you hold the input button and POWER button the input button doesn't 
flash so I can turn the dial knob on the 7800 and calibrate it.

I'd hate to think this is DOA all the way here.

Any suggestions would be appreciated.
73
Don
N1DG

-----------------------------------------------------
N1DG--Licensed since 1962
EX-WB2DND, A61AD (GUEST OP, QSL MGR), A52DG, /KH9, /BV, /VS6, /4X, /9V
Pilot:  VU7RG, 3Y0X, VK9ML, D68C, VK0IR, K8XP/KH9, 9M0C, ZK1XXP, ZL9CI
Webmaster: BS7H, K5K, A52A, VK0IR, 9M0C, ZK1XXP, WB2DND/KH9, BQ9P, ZL9CI
QSL Manager:  A61AD, A61AO, A61X, A61AQ, KH7Z
Member:  FOC, ARRL, DDXA, YCCC
2006 Inductee into the CQ DX Hall of Fame
DON GREENBAUM , DUXBURY, MA, USA
AIM:  aurumtel


----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/