*****SPAM***** Re: [ICOM] IC-706 Set Mode Problem

[Gary Fiber]

Well if the reset does not work and you followed the instruction manual 
exactly for installing and enabling the filter, then I would figure the 
rig is in trouble.
Not much else to do.
I figure the eeprom is where the filter settings are stored and that 
device might be bad or that section. The theory of operation in the 
service manual would likely tell a bit more where the filter settings 
are stored.

Gary K8IZ

John Germanos wrote:
> TNX response but the problem is, the changes are not remembered. Any 
> thoughts would be appreciated.
>
> John WB9PNU
>
> ----- Original Message ----- From: "roncasa" <roncasa at verizon.net>
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Sent: Sunday, August 26, 2007 4:27 PM
> Subject: Re: [ICOM] IC-706 Set Mode Problem
>
>
>> John Germanos wrote:
>>> I am having trouble with my 706MkIIG. If I change something in 
>>> Initial Set Mode, it is not remembered. Tried CPU reset, but did not 
>>> help. Trying to set up a new filter I added.
>>>
>>
>> refer to page 51 in owner's manual:
>>
>> while pushing power on, press and hold down "lock"
>>
>> turn tuning dial to number "9" or "10" depending on filter location;
>>
>> select filter
>>
>> press and hold down power button till radio goes off.
>>
>>
>> ----
>> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>>
>>
>> -- 
>> No virus found in this incoming message.
>> Checked by AVG Free Edition. Version: 7.5.484 / Virus Database: 
>> 269.12.8/973 - Release Date: 8/25/2007 5:00 PM
>>
>>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
>