[ICOM] Icom IC-02 AT, 2 m HT FS

[Gary Fiber]

Sheldon,

Hopefully that gets Ken working. If not then his 02AT likely has a 
faulty out of band modification.
There was a difference between the early and late CPU's how to set the 
Duplex

Gary K8IZ


>    Close  for  the  Duplex  frequency  separation,  but DON'T release the
>    function key.
>
>    Depress  FUNC  and  hold, press "7-Shift" then the proper direction of
>    the  offset  (*  for minus or # for plus) then four digit keys for the
>    offsett (usually 0600), then release the FUNC key.
>
>    There  is  a special consideration for the IC-02AT.  Whatever tone and
>    duplex  offset  programmed into memory channel 1 will also be the same
>    offset/tone for M1-M6.  M7 through M0 may have independent offsets and
>    tone assignments.
>
>    73
>
>    Sheldon
>
>    WA4MZZ
>
>    
>    
>    
>    ----- Original Message -----
>
>    From: Gary Fiber <gfiber at clearwire.net>
>
>    Date: Saturday, November 18, 2006 7:51 pm
>
>    Subject: Re: [ICOM] Icom IC-02 AT, 2 m HT FS
>
>    > Ken,
>    >
>    > I still think its FUNC then while holding the FUNC button choose
>    > the
>    > desired direction of offset release the function. Now Press the
>    > FUNC
>    > again. then the " 7 " then amount of offset on 4 digits then
>    > release the
>    > FUNC button..
>    >
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
>
>