[ICOM]PW-1 ALC

[lmorris]

In a pinch, just the exciter 2 position, till you have a chance to fix 
exciter one.. Better than blowing the amp!
I set mine for 900 watts to be safe..
GL
Len VE3FJB

----- Original Message ----- 
From: "Tony Visco" <ahv73 at verizon.net>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Sent: Sunday, January 15, 2006 6:47 PM
Subject: RE: [ICOM]PW-1 ALC


>
> Ouch,
>
> I was installing a new exciter and was adjusting the ALC which is a little
> difficult because of my remote location for the Linear.  Unfortunately I
> feel it is difficult to feel the adjusting screw move and of course the
> plastic adjustment made a snap sound which meant I may have pushed a 
> little
> hard.
>
> It is now on a bit of an angle and of course the ALC is spiking over the
> recommended setting.
>
> Is this a component that is accessible?? If so could I likely adjust it 
> with
> the damaged plastic adjustment?
>
> Is this a component that can be replaced by me?
>
> Any helpful advice will be appreciated.
>
> Tony W3EW
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.371 / Virus Database: 267.14.18/230 - Release Date: 1/14/2006
>
>