[ICOM]PW-1 ALC

[Tony Visco]

Ouch,

I was installing a new exciter and was adjusting the ALC which is a little
difficult because of my remote location for the Linear.  Unfortunately I
feel it is difficult to feel the adjusting screw move and of course the
plastic adjustment made a snap sound which meant I may have pushed a little
hard. 

It is now on a bit of an angle and of course the ALC is spiking over the
recommended setting.

Is this a component that is accessible?? If so could I likely adjust it with
the damaged plastic adjustment?

Is this a component that can be replaced by me?

Any helpful advice will be appreciated.

Tony W3EW