[ICOM] 756 Pro No power out

[jim fox]

I was on phone,but since I started trouble shooting , the mike is unpluged 
and using the key in CW to check power out.. Thanks,   Jim


>From: MikeR <nf4l at nf4l.com>
>Reply-To: ICOM Reflector <icom at mailman.qth.net>
>To: ICOM Reflector <icom at mailman.qth.net>
>Subject: Re: [ICOM] 756 Pro No power out
>Date: Fri, 10 Feb 2006 09:16:03 -0500
>
>Bonddaleena at aol.com wrote:
>>In a message dated 2/9/2006 8:12:26 PM Eastern  Standard Time, 
>>w0hfg at hotmail.com writes:
>>I just worked 3Y0X on 15 meters  about 3 pm this afternoon and then about 
>>5 pm I noticed they were on 20  meters. I started calling and noticed I 
>>didn't have much power out. I'm  driving a 4KL amp with about 40 watts. I 
>>stopped and checked all bands an I  only have about 2 - 5 watts out with 
>>the RF Power control fully clockwise..  I disconnected the coax from the 
>>rig and attached a bird 43 to a DummyLoad  to make the power readings. 5 
>>watts out on 40 & 80 and 2 watts out on  20,15 & 160. Didn't check 10 or 6 
>>meters. No smoke no noise just no  power out.. Rx works fine. Tx spike on 
>>the spectrum scope looks fine..  Haven't looked inside yet..
>>Anyone have any ideas where to  check first ???
>>
>>Thanks,   Jim / W0HFG
>If you were on phone, un-plug the mic and plug it back in. Works on my Pro 
>II.
>GL & 73
>Mike NF4L
>----
>Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>Icom Users Net: Sundays, 1700Z, 14.316 MHz
>Icom FAQ: http://www.qsl.net/icom/