[ICOM] IC2100H

[David Ashworth]

Hi Jim, my buddy also has the same rig.  While we were talking, his signal
would cut on and off.  He traced it to the mike switch.  Think he put some
contact cleaner on it and it is working now.  Here is another recommendation
from a
fellow ham when I asked the same question for my buddy:  "Reflow the solder
connection on the circuit board. Build it up a little if possible. I did
this for a friend on his V8K-same mic, and has worked well for over a  year
since.
 And it gets a lot of exercise . 73 & GL Rick."  I have a Kenwood 2 meter
rig and all of a sudden the audio will go out but still keys the radio.
Perhaps, the microphone is the Achilles heel.  Best regards, Dave, NC6P




----- Original Message ----- 
From: "Jim Vohland" <n9vo at hotmail.com>
To: <icom at mailman.qth.net>
Sent: Saturday, August 27, 2005 20:33
Subject: [ICOM] IC2100H


> While on way to work today, the 2100 mobile stopped transmitting. NO
> indication of radio going into transmit at all instead of no output.
> Thinking perhaps it is a mic problem but at work unable to try another
mic.
> Guess the mic from a 207 will at least key it up. Just wondering if anyone
> would have experienced this before. I did try a reset and no change.
Buttons
> on ther mic seem to work, it just will not key the radio to xmit. Any
> input????
>
> _________________________________________________________________
> On the road to retirement? Check out MSN Life Events for advice on how to
> get there! http://lifeevents.msn.com/category.aspx?cid=Retirement
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.344 / Virus Database: 267.10.16/83 - Release Date: 8/26/2005
>
>