[ICOM] PW-1 problem

[Ken Kinyon]

Hi Chuck,
I ran into the same ground wire anomaly.

there apparently is none.
regards,
Ken W7TS

-------------------
Kenneth E.  Kinyon
34 Princeton Circle
Longmont, CO 80503-2106
-----------------------
E-mail: W7TS at comcast.net
------------------

-----Original Message-----
From: icom-bounces at mailman.qth.net
[mailto:icom-bounces at mailman.qth.net]On Behalf Of Chuck Kresge
Sent: Wednesday, December 29, 2004 10:26
To: ICOM Reflector
Subject: [ICOM] PW-1 problem


I need some help with my new PW-1.

I have an IC-756PROII and just received a PW-1 amplifier. During the
separation of the remote controller from the amplifier I noticed on page 10
of the PW-1 manual in step 8 it says "Connect the grounding wire as shown
below." I never could find that grounding wire and cannot see it in the
illustration and then continued to complete the separation of the remote
controller. My amplifier is working with my IC-756PROII except that I cannot
get the amplifier to automatically change bands with the PW-1 and my CT-17
installed with my computer.

Can someone give me information on this grounding wire?

Thanks very much-Chuck Kresge DU3NXE du3nxe at mozcom.com

----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Win a new Icom IC-756 PRO III and help QSL/QTH.net
Details at: http://mailman.qth.net/