[ICOM] ICOM 706 MK2G

[Jens Schmidt]

Hi Bob,

that sounds familiar, although I saw it on my IC-910H - 1296MHz module.
What appeared to be the fix here was to open up and in the process remove
all the cable connections, find nothing suspect, _clean_ the cable connections,
especially the flat ribbon cables, reassemble carefully.
Problem not seen since !

Good luck, 73 Jens    ZL2TJT

WORKSNTV at aol.com wrote:

> I am running the 706 MK2G and have run into a problem--I am hoping someone
> out there has an idea--
> When transmitting, on any band, using SSB, I get full power,
> 100watts---however in the middle of the transmission the power goes to zero---If I unkey the
> mike and then key up again---full power--
> It may seem like just an inconvenience---but it's getting to be a real pain..
> SWR is OK...
> Any ideas???
>
> Tnx, Happy Holidays and 73'
>
> Bob
> WB3DYE