[Icom] low output on IC 756
Nathan Moreschi
[email protected]
Mon, 30 Dec 2002 20:02:25 -0000
Hello Per. The result is the same.
Thanks,
Nate/N4YDU
----- Original Message -----
From: "OZ1EQC" <[email protected]>
To: <[email protected]>
Sent: Monday, December 30, 2002 6:58 PM
Subject: Re: [Icom] low output on IC 756
> Hi Nate
>
> How is the result with the antanna tuner ?
>
> Per OZ1EQC
>
>
> ----- Original Message -----
> From: "Nathan Moreschi" <[email protected]>
> To: <[email protected]>
> Sent: Monday, December 30, 2002 7:51 PM
> Subject: Re: [Icom] low output on IC 756
>
>
> > Hi Cletus. Thanks for the reply. The power tops off at 70 percent with
the
> > power knob at about 70 percent. There is no increase with the knob
tunred
> > all the way to the right.
> >
> > Does this help?
> >
> > 73,
> >
> > Nate/N4YDU
> > ----- Original Message -----
> > From: "Cletus W Whitaker" <[email protected]>
> > To: <[email protected]>
> > Sent: Monday, December 30, 2002 6:44 PM
> > Subject: Re: [Icom] low output on IC 756
> >
> >
> > > de WB2CPN South Central Pennsylvania 2002.12.30
> > >
> > > With all tuning and adjustments properly made, you could reduce the
> > > front panel RF Power control all the way down; then slowly run it
> > > up while watching the power output. Question: Does the power output
> > > slowly increase up to the 70% point then hold even though the RF
> > > Power control knob is turned up further? Or does the power output
> > > reach 70% when the RF Power control knob tops out? You don't have
> > > anything pluged into the back that clamps the AGC do you?
> > > 73 Clete
> > > ----
> > > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > > Icom Users Net: Sundays, 1700Z, 14.315 MHz
> > > Icom FAQ: http://www.qsl.net/icom/
> > >
> >
> > ----
> > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > Icom Users Net: Sundays, 1700Z, 14.315 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> >
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/