[Icom] low output on IC 756

Mon, 30 Dec 2002 19:58:50 +0100

Hi Nate

How is the result with the antanna tuner ?

Per  OZ1EQC

----- Original Message -----
From: "Nathan Moreschi" <[email protected]>
To: <[email protected]>
Sent: Monday, December 30, 2002 7:51 PM
Subject: Re: [Icom] low output on IC 756

> Hi Cletus. Thanks for the reply. The power tops off at 70 percent with the
> power knob at about 70 percent. There is no increase with the knob tunred
> all the way to the right.
>
> Does this help?
>
> 73,
>
> Nate/N4YDU
> ----- Original Message -----
> From: "Cletus W Whitaker" <[email protected]>
> To: <[email protected]>
> Sent: Monday, December 30, 2002 6:44 PM
> Subject: Re: [Icom] low output on IC 756
>
>
> > de WB2CPN South Central Pennsylvania   2002.12.30
> >
> > With all tuning and adjustments properly made, you could reduce the
> > front panel RF Power control all the way down; then slowly run it
> > up while watching the power output.  Question: Does the power output
> > slowly increase up to the 70% point then hold even though the RF
> > Power control knob is turned up further?  Or does the power output
> > reach 70% when the RF Power control knob tops out?  You don't have
> > anything pluged into the back that clamps the AGC do you?
> >                       73  Clete
> > ----
> > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > Icom Users Net: Sundays, 1700Z, 14.315 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> >
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
>