[Hallicrafters] How To Unsolder Can Capacitors (or anything else?)

[rbethman]

It depends on "WHICH" Pace station.

They too have different models.

When someone talks about "small pcb repair", they haven't used the Pace 
stations that I have.

I've used Pace Stations that EASILY desolder 7 to 9 layer PCBs on a 
ground that incorporates ALL layers.

The Military used to use them and some other neat "toys" to be able to 
go down through that 7 to 9 layer board, and build it back up including 
the in between traces.

Spent quite awhile doing those type of repairs.  Learned tubes *after* 
working all that solid state gear.

Bob - N0DGN

On 3/12/2013 3:21 PM, Paul Kraemer wrote:
> Might
> Pace is good unit but my experience with them is limited to small pcb 
> repair. They do a good job there
> Paul K0UYA
> ----- Original Message ----- From: "Jammer" <zengmeiste at aol.com>
> To: <hallicrafters at mailman.qth.net>
> Sent: Tuesday, March 12, 2013 1:54 PM
> Subject: [Hallicrafters] How To Unsolder Can Capacitors (or anything 
> else?)
>> Hmm, would a PACE PPS-5 do the trick?  I have one I'm (probably)
>> not going to use..
>>
>>  73 Terry KC9KEL