[Hallicrafters] S-38 Series Relacement Feet]

[Charlie]

Collins, Heath, Hallicrafters etc. rubber feet




I have a large quantity of these available.  As far as I can tell,
they are identical to the rubber feet used on Collins, Hallicrafters and 
many
other brand radios.  These are all current USA production.
A stainless steel #6 flat washer is included,  but no mounting
hardware or risers.

I will sell them in packs of 12  for  $5.00 + $1.00 shipping
($2.00 international), or in bags of 100 for $31.00 + $6.00
shipping ($10 international).   Note, the $1.00 shipping will
cover two 12 packs.
Add $1.00 shipping for each extra 100 pieces you need.


You can send the payment to:
Charlie Talbott, 13192 Pinnacle Lane, Leesburg VA 20176-6146 USA.


----- Original Message ----- 
From: "Ka Nai`a" <groups at dolphinhome.net>
To: <Hallicrafters at mailman.qth.net>
Sent: Thursday, January 26, 2006 2:41 PM
Subject: RE: [Hallicrafters] S-38 Series Relacement Feet]


> Hey Don,
>
> I had the same thing on my S-38A but the feet didn't actually go into
> the chassis. The screws went into the chassis through the feet but not
> the foot. Take a look at this picture here,
> http://dolphin.podzone.net/Radio/feet.jpg
> Those are my old and new feet. I just got some feet from Fry's
> Electronics and bored the right sized hole through it for the screw with
> a junker soldering iron. The product number on these are PAD-5009H. I
> also had to remove the sticky stuff with a piece of sandpaper so it
> wouldn't rip the bottom off and I could take them off easily.
>
> -Ka Nai`a
>
> -----Original Message-----
> From: hallicrafters-bounces at mailman.qth.net
> [mailto:hallicrafters-bounces at mailman.qth.net] On Behalf Of
> vanwagnd at bellsouth.net
> Sent: Thursday, January 26, 2006 10:08 AM
> To: hallicrafters at mailman.qth.net
> Subject: [Hallicrafters] S-38 Series Relacement Feet]
>
>
> Hello to the list:    Does anyone know of a source for the rubber feet
> used on the bottom of the S-38 series...these are the feet that slide
> into the slot in the case and insulate the chassis from the case.   If
> no source, any ideas on making some from whatever material??
>> > Thanks,
>> > Don
>>    K4LAJ
>> >
>>
>
>
> ______________________________________________________________
> Hallicrafters mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:Hallicrafters at mailman.qth.net
> ----
> List Administrator: Duane Fischer, W8DBF **for assistance**
> dfischer at usol.com
> ----
> Hallicrafters Collectors International: http://www.w9wze.org
>