[Hallicrafters] S-38 Series Relacement Feet]

[Ka Nai`a]

Hey Don, 

I had the same thing on my S-38A but the feet didn't actually go into
the chassis. The screws went into the chassis through the feet but not
the foot. Take a look at this picture here, 
http://dolphin.podzone.net/Radio/feet.jpg
Those are my old and new feet. I just got some feet from Fry's
Electronics and bored the right sized hole through it for the screw with
a junker soldering iron. The product number on these are PAD-5009H. I
also had to remove the sticky stuff with a piece of sandpaper so it
wouldn't rip the bottom off and I could take them off easily.

-Ka Nai`a

-----Original Message-----
From: hallicrafters-bounces at mailman.qth.net
[mailto:hallicrafters-bounces at mailman.qth.net] On Behalf Of
vanwagnd at bellsouth.net
Sent: Thursday, January 26, 2006 10:08 AM
To: hallicrafters at mailman.qth.net
Subject: [Hallicrafters] S-38 Series Relacement Feet]


 Hello to the list:    Does anyone know of a source for the rubber feet
used on the bottom of the S-38 series...these are the feet that slide
into the slot in the case and insulate the chassis from the case.   If
no source, any ideas on making some from whatever material??
> > Thanks,
> > Don
>    K4LAJ
> > 
>