[GreenKeys] Hqppy 4th! 3d printed keys, and a 14 issue

[Eric Moore]

A 14 chatters again!

https://youtu.be/UVSCk7ly5W0

The top / first code bar is not properly moving, and the bell I think is
the paper warning arm.

I have a spare encoder that came with the spare printer, so I am going to
do a transplant. It is only a partial encoder, but it has the piece that is
broken on mine.

I have Mike Douglas's RS232 adapter ready to go, so once I address the 1st
code bar I can send it some characters :)

Thank you all for the help!

-Eric

On Tue, Jul 4, 2023 at 2:42 PM Eric Moore <mooreericnyc at gmail.com> wrote:

> https://youtu.be/3EXzbT7oKTA
>
> Little update, I think I have the printer adjusted. Now I am struggling
> with the cam stack pushing a release out of the way at the right time to
> prevent the main shaft seizing.
>
> -Eric
>
> On Tue, Jul 4, 2023, 8:32 AM Eric Moore <mooreericnyc at gmail.com> wrote:
>
>> Hi all, happy 4th for those in the US!
>>
>> First, attached you will find my first attempts at 3d printed key
>> replacements. These are on my GPE perforator. Not perfrct, but better than
>> nothing!
>>
>> Second, https://youtu.be/5lkIvRWcB4A
>>
>> This new model 14 printer I received appears to be further bent, or I
>> missed an alignment when mating the printer to the main shaft.
>>
>> I am about ready to try and go back to the old frozen up printer, which
>> at least fully cycled properly. I am reading the manuals, but printer
>> replacement instructions I have not found.
>>
>> If anyone has any ideas before I begin deep cleaning the old printer, I
>> am all ears! Thanks!
>>
>> -Eric
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20230706/b064f602/attachment.html>