[GreenKeys] thread on 14KTR

[simon]

Hi All,

I'm working to get our 14KTR working again, but one guide shaft is 
broken of the small platen block. its the sift support sticking out at 
the front of the machine. what is the type of thread used on this shaft? 
As I am living in a metric oriented landmass, searching for a potential 
replacement did not result in any screw fitting. I am inclined to 
retread it with metric 4, as the shaft itself is 4mm, but before doing 
something irreversible, I wanted to ask here.
-- 
Met vriendelijke Groet,

Simon Claessen
drukknop.nl