[GreenKeys] Signal Generator adjustment

[Randy and Sherry Guttery]

On 12/12/2010 6:41 PM, Larry Tighe wrote:
> Howdy Folks,
>
> My Model 35 is erratically typing garbage.  I traced the problem to the signal generator.  There is a small arm that goes into the side of the generator and is moved back and forth by the keyboards action.
>
> I found that by a little finger pressure on the arm to the left, it again prints perfectly.  I see there is no adjustment inside the signal generator (not obvious is there is one) and I don't see how to adjust the arm so as to accomplish that small to-the-left correction or pressure to correct the problem.
>
> So, is there an adjustment for this arm to get it where I need it?  BTW, it is the same configuration on a Model 28 signal generator.
Doesn't the whole signal gen "box" adjust? (like a 28)...  
look for a "lock screws" to the right and left of the box - 
and a horiz. adjust screw a little further to the left...

best!

-- 
randy guttery

A Tender Tale - a page dedicated to those Ships and Crews
so vital to the United States Silent Service:
http://tendertale.com