[GreenKeys] Signal Generator adjustment

[Larry Tighe]

Howdy Folks,

My Model 35 is erratically typing garbage.  I traced the problem to the signal generator.  There is a small arm that goes into the side of the generator and is moved back and forth by the keyboards action.

I found that by a little finger pressure on the arm to the left, it again prints perfectly.  I see there is no adjustment inside the signal generator (not obvious is there is one) and I don't see how to adjust the arm so as to accomplish that small to-the-left correction or pressure to correct the problem.

So, is there an adjustment for this arm to get it where I need it?  BTW, it is the same configuration on a Model 28 signal generator.

Thanks,
Lar