[Elecraft] K3 sidetone volume when using Line Out

[Barry]

Thanks for the replies.  I'll pass it along to the station owner.

73,
Barry W2UP

On 11/28/2021 11:27 AM, Geert Jan de Groot wrote:
>
>> Was operating remote in CQWW using a K3 and RCforB.? I was unable to
>> adjust the sidetone volume, which I found too loud.? The host is using
>> Line Out to connect to the sound card, which provides a fixed audio
>> level.? is there a way to independently adjust the sidetone level via
>> Line out?
>
> Respectfully adding to Pete's response: "sidetone level on line out" 
> to me means the amount of audio on the line out output while you are 
> transmitting, to "monitor" your own transmissions.
>
> If this is what you are after, there is ab obscure description in the 
> release notes of the K3 5.88 firmware description:
>
> TX LINE OUT (MONITOR) LEVEL NOW ADJUSTABLE:
> In CONFIG:LIN OUT menu entry, tap '2'  (REV switch) to set the "T=" 
> level (TX monitor). Tap '2' again to return to the RX LINE OUT setting.
>
> Hope this helps,
>
> Geert Jan