[Elecraft] K3 sidetone volume when using Line Out

[Geert Jan de Groot]

> Was operating remote in CQWW using a K3 and RCforB.? I was unable to
> adjust the sidetone volume, which I found too loud.? The host is using
> Line Out to connect to the sound card, which provides a fixed audio
> level.? is there a way to independently adjust the sidetone level via
> Line out?

Respectfully adding to Pete's response: "sidetone level on line out" to 
me means the amount of audio on the line out output while you are 
transmitting, to "monitor" your own transmissions.

If this is what you are after, there is ab obscure description in the 
release notes of the K3 5.88 firmware description:

TX LINE OUT (MONITOR) LEVEL NOW ADJUSTABLE:
In CONFIG:LIN OUT menu entry, tap '2'  (REV switch) to set the "T=" 
level (TX monitor). Tap '2' again to return to the RX LINE OUT setting.

Hope this helps,

Geert Jan