[Elecraft] K3S poor CW keying further investigation

[Bob McGraw K4TAX]

Change the connectors on the power supply to accommodate several ring 
type connectors.   Use 1" long   #10 bolts, nuts, flat washers and 
insulating washers which are easy to find at your local hardware store 
and are very easy to use and replace.  Then you can connect 8 to 10 
pieces of equipment to one power supply.

Remember, we are ham radio operators and that is what we've always 
done.   But as I have done, with two stations, I have two power supplies.

73

Bob, K4TAX


On 4/25/2020 10:42 AM, Don Wilhelm wrote:
> Solder each power supply lead to a short length of #10 wire.  Insulate 
> the connection well.
>
> 73,
> Don W3FPR
>
> On 4/25/2020 11:12 AM, Ron Manfredi wrote:
>> Fewer power supplies (meaning the switching type) have actual 
>> terminal bolts to use with ring connectors.  If the supply doesn't 
>> have that type of connector, then what alternatives are there to 
>> being able to use one supply in a station that has more than one high 
>> current rig,  (even if they are not used at the same time) since the 
>> connectors on most of these supplies will take at most only one 10-12 
>> gauge cable?
>>
>> Ron   WA2EIO
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net