[Elecraft] sdr play and K3S

[Bob McGraw K4TAX]

I’ve used the RSP-1a with HDSDR.  I had to set the calibration for overall and then for each mode. Some values were + and some - .  Also I found my SDR Play RSP-1a does drift noticeably.  

Finall tossed the thing in the drawer and purchased a P3.  Much more satisfactory.  

Bob, K4TAX


Sent from my iPhone

> On Apr 9, 2020, at 8:28 PM, Don Sayler <dons at ieee.org> wrote:
> 
> Hi Everyone.
> 
> 
> 
> I've been trying to get my SDRPlay (w/ SdrUno) to work with the IF output of
> my K3S.
> 
> I've got OmniRig set up, so the K3S and SdrUno interact properly. Well,
> almost.
> 
> 
> 
> There seems to be an offset between the K3S frequency and the SdrUno
> frequency. For example, I dial in WWV at 10 MHz on the K3S, and SdrUno hears
> the signal at ~9.875 MHz.
> 
> On 80m, this offset is around 117KHz.  I've tried the setting the External
> Converter offsets, that didn't help.
> 
> 
> 
> In SdrPlay, I do have the IF Output Frequency set to 8125000 Hz and it is
> enabled. I've tried adjusting this value a little, and it didn't seem to
> help.
> 
> I am aware of some of the limitations of SdrUno compared to other software,
> but this is the one that I'm used to. I may switch to another one at some
> point.
> 
> 
> 
> Any ideas? I looked through the K3S config settings, and nothing jumped out
> at me.
> 
> 
> 
> Thanks!
> 
> 
> 
> 73,
> 
> Don W7OXR
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net 
>