[Elecraft] sdr play and K3S

[Don Sayler]

Hi Everyone.

 

I've been trying to get my SDRPlay (w/ SdrUno) to work with the IF output of
my K3S.

I've got OmniRig set up, so the K3S and SdrUno interact properly. Well,
almost.

 

There seems to be an offset between the K3S frequency and the SdrUno
frequency. For example, I dial in WWV at 10 MHz on the K3S, and SdrUno hears
the signal at ~9.875 MHz.

On 80m, this offset is around 117KHz.  I've tried the setting the External
Converter offsets, that didn't help.

 

In SdrPlay, I do have the IF Output Frequency set to 8125000 Hz and it is
enabled. I've tried adjusting this value a little, and it didn't seem to
help.

I am aware of some of the limitations of SdrUno compared to other software,
but this is the one that I'm used to. I may switch to another one at some
point.

 

Any ideas? I looked through the K3S config settings, and nothing jumped out
at me.

 

Thanks!

 

73,

Don W7OXR