[Elecraft] Keep getting BAT Err message

[rich hurd WC3T]

I'd swap out the batteries and then go through the procedure that Don
recommends.

Dumb question; they are all NiMH, right?  Hopefully Eneloop or a similar
marque?

On Thu, May 31, 2018 at 17:06 Don Wilhelm <donwilh at embarqmail.com> wrote:

> Bob,
>
> Read the BAT ERR description on page 4 of the KXBC3 manual.
>
> You may have to remove the batteries and check the terminal voltage of
> each one with your DMM to determine if you have a bad one, or if all are
> possibly fully charged.
>
> Reloading software will not make any difference, but likely will not
> hurt anything either.
>
> 73,
> Don W3FPR
>
> On 5/31/2018 4:51 PM, Bob G3PJT wrote:
> > When I try to charge the battery I get Bat err message and charging is
> > terminated. I have reloaded s/ware etc but no change.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rich at wc3t.us
>
-- 
72,
Rich Hurd / WC3T / DMR: 3142737
PA Army MARS, Northampton County RACES, EPA-ARRL Public Information Officer
for Scouting
Latitude: 40.761621 Longitude: -75.288988  (40°45.68' N 75°17.33' W) Grid:
*FN20is*