[Elecraft] K3S TX Noise Gate

[Jim Brown]

The original question was about TX Noise Gate.  How did we get onto TXEQ?

To some extent, TX EQ settings depend on the mic and voice. For 
competitive, good sounding audio to cut through QRM and noise, a good 
starting point for most ham mics and average voices is max cut of the 
three lowest EQ bands, 6 dB cut of the fourth, 6 dB boost of the top two 
bands, 0 dB (no boost, no cut) for the remaining bands. Once these 
setting are made, set Comp to see 10 dB of compression on peaks, and get 
reports from a good listener.

73, Jim K9YC