[Elecraft] K3S TX Noise Gate

[Don Wilhelm]

The boost at high frequencies will allow the mic audio to pick up 
extraneous room noise, and may override (interfere) with the operation 
of the noise gate.

Jim is correct on all other counts.

73,
Don W3FPR

On 3/18/2018 9:41 PM, Jim Brown wrote:
> The original question was about TX Noise Gate.  How did we get onto TXEQ?
> 
> To some extent, TX EQ settings depend on the mic and voice. For 
> competitive, good sounding audio to cut through QRM and noise, a good 
> starting point for most ham mics and average voices is max cut of the 
> three lowest EQ bands, 6 dB cut of the fourth, 6 dB boost of the top two 
> bands, 0 dB (no boost, no cut) for the remaining bands. Once these 
> setting are made, set Comp to see 10 dB of compression on peaks, and get 
> reports from a good listener.