[Elecraft] K2 BFO CW alignment question

[Mark Petrovic]

Don, thanks.

When I exit CAL FIL, and press and hold CW RV, I see "ST P 0.60" displayed
(with the B RIT and XIT annunciators on) whether in CW, USB or LSB mode.

On Sun, Jun 10, 2018 at 2:21 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:

> Mark,
>
> Get out of the CAL FIL menu and see if it does toggle the bar when in CW
> mode.  In SSB mode, it should toggle between LSB and USB.
> If it works in SSB mode, but not in CW, you may have a display fault that
> is not showing the bar - that is a different problem.
>
> 73,
> Don W3FPR
>
>
> On 6/10/2018 4:44 PM, Mark Petrovic wrote:
>
>> Thanks, Don.  In CAL FIL mode, holding CW RV does not toggle a bar over
>> the "c".  All my calibrations and tests have gone swimmingly til now.  Any
>> suggestions on where to start to troubleshoot this?  Is there another way
>> to verify if the toggle is being honored (could the over-bar LCD element be
>> bad?)?
>>
>
>


-- 
Mark