[Elecraft] K2 BFO CW alignment question

[Don Wilhelm]

Mark,

That indicates you are not getting the right button response.
Check the Front Panel Board.  My immediate guess is that you have a 
soldering problem on RP1, or that RP1 is inserted backwards. That is one 
of the R-Paks that MUST be inserted in the proper orientation.  Look at 
the board silkscreen for the pin 1 location, and look for the dot at the 
end of the R-Pak - they must be aligned.

You could also have a solder splash somewhere on the FP board.

73,
Don W3FPR

On 6/10/2018 5:31 PM, Mark Petrovic wrote:
> Don, thanks.
>
> When I exit CAL FIL, and press and hold CW RV, I see "ST P 0.60" 
> displayed (with the B RIT and XIT annunciators on) whether in CW, USB 
> or LSB mode.
>
> On Sun, Jun 10, 2018 at 2:21 PM, Don Wilhelm <donwilh at embarqmail.com 
> <mailto:donwilh at embarqmail.com>> wrote: