[Elecraft] K2 BFO CW alignment question

[Don Wilhelm]

Mark,

Get out of the CAL FIL menu and see if it does toggle the bar when in CW 
mode.  In SSB mode, it should toggle between LSB and USB.
If it works in SSB mode, but not in CW, you may have a display fault 
that is not showing the bar - that is a different problem.

73,
Don W3FPR

On 6/10/2018 4:44 PM, Mark Petrovic wrote:
> Thanks, Don.  In CAL FIL mode, holding CW RV does not toggle a bar 
> over the "c".  All my calibrations and tests have gone swimmingly til 
> now.  Any suggestions on where to start to troubleshoot this?  Is 
> there another way to verify if the toggle is being honored (could the 
> over-bar LCD element be bad?)?