[Elecraft] K2 BFO CW alignment question

[Mark Petrovic]

Thanks, Don.  In CAL FIL mode, holding CW RV does not toggle a bar over the
"c".  All my calibrations and tests have gone swimmingly til now.  Any
suggestions on where to start to troubleshoot this?  Is there another way
to verify if the toggle is being honored (could the over-bar LCD element be
bad?)?

Mark

On Sun, Jun 10, 2018 at 12:55 PM, Don Wilhelm <donwilh at embarqmail.com>
wrote:

> Mark,
>
> The CW reverse is indicated by a bar over the "c" to the right of the
> display.  Holding the REV button should toggle it.
> Likewise, that same button will toggle between USB and LSB.
>
> 73,
> Don W3FPR
>
>
> On 6/10/2018 3:37 PM, Mark Petrovic wrote:
>
>> I am performing the first alignment and test of the RF board of my K2 S/N
>> 7809.  On page 66 of the manual, I'm instructed to read page 91 of the
>> operating instructions to get familiar with the CAL FIL settings.  Page 91
>> says to work through the CAL FIL examples on page 93, wherein we work
>> through setting the BFO frequencies.  One of the steps says to hold CW RV
>> to switch to CW Reverse.  When I press and hold CW RV, should I expect
>> some
>> visual element to change to indicate that I am in this 'reverse' mode?  I
>> don't see any visual indication.  How do I know the press and hold of CW
>> RV
>> was effective?
>>
>


-- 
Mark