[Elecraft] K2 BFO CW alignment question

[Don Wilhelm]

Mark,

The CW reverse is indicated by a bar over the "c" to the right of the 
display.  Holding the REV button should toggle it.
Likewise, that same button will toggle between USB and LSB.

73,
Don W3FPR

On 6/10/2018 3:37 PM, Mark Petrovic wrote:
> I am performing the first alignment and test of the RF board of my K2 S/N
> 7809.  On page 66 of the manual, I'm instructed to read page 91 of the
> operating instructions to get familiar with the CAL FIL settings.  Page 91
> says to work through the CAL FIL examples on page 93, wherein we work
> through setting the BFO frequencies.  One of the steps says to hold CW RV
> to switch to CW Reverse.  When I press and hold CW RV, should I expect some
> visual element to change to indicate that I am in this 'reverse' mode?  I
> don't see any visual indication.  How do I know the press and hold of CW RV
> was effective?