[Elecraft] Filters

[ab2tc]

Hi,

You don't have to do any math to do this. Just go to shift/width and change
the width one click (either direction.). Then switch back to HiCut/LoCut. To
reverse the process, do the same thing again.

AB2TC - Knut


Joe Subich, W4TV-4 wrote
>> One question: On my K3S I cannot set the LO CUT to .35KHz it only 
>> steps in .10 increments not 0.05 increments is there some CONFIG
>> item I need to change?
> Temporarily switch to Shift/Width and set Shift to a value that,
> when divided by two results in a value of X.X5.  Now switch back
> to Hi/Lo ... those value will end in X.X5 and step in increments
> of X.10.
> 
> 73,
> 
>     ... Joe, W4TV
> <snip>





--
Sent from: http://elecraft.365791.n2.nabble.com/