[Elecraft] Filters

[Don Wilhelm]

On SSB a change of 50Hz bandwidth is usually insignificant.
Those who are blessed with perfect pitch may differ when listening to a 
single tone, but for communications effectiveness, I just don't see the 
point.

73,
Don W3FPR


On 7/1/2018 9:34 AM, ab2tc wrote:
> Hi,
> 
> You don't have to do any math to do this. Just go to shift/width and change
> the width one click (either direction.). Then switch back to HiCut/LoCut. To
> reverse the process, do the same thing again.
> 
> AB2TC - Knut
> 
> 
> Joe Subich, W4TV-4 wrote
>>> One question: On my K3S I cannot set the LO CUT to .35KHz it only
>>> steps in .10 increments not 0.05 increments is there some CONFIG
>>> item I need to change?
>> Temporarily switch to Shift/Width and set Shift to a value that,
>> when divided by two results in a value of X.X5.  Now switch back
>> to Hi/Lo ... those value will end in X.X5 and step in increments
>> of X.10.