[Elecraft] Filters

[Joe Subich, W4TV]

> One question: On my K3S I cannot set the LO CUT to .35KHz it only 
> steps in .10 increments not 0.05 increments is there some CONFIG
> item I need to change?
Temporarily switch to Shift/Width and set Shift to a value that,
when divided by two results in a value of X.X5.  Now switch back
to Hi/Lo ... those value will end in X.X5 and step in increments
of X.10.

73,

    ... Joe, W4TV


On 2018-06-30 10:31 PM, Michael Gillen via Elecraft wrote:
> Good info on the filters I had never tried the LO/HI CUT and I like it. One question: On my K3S I cannot set the LO CUT to .35KHz it only steps in .10 increments not 0.05 increments is there some CONFIG item I need to change? I looked through the CONFIG menus and Fred Cady’s book however I did not see anything about setting that step.
> 
> 73,
> Michael
> KK6RWK
> 
> 
>> On Jun 30, 2018, at 5:37 PM, Bill Frantz <frantz at pwpconsult.com> wrote:
>>
>> Congratulations. The K3 is a really nice radio with extraordinary factory support.
>>
>> For SSB, I set low cut to .35 KHz and adjust the upper cut between 1.9 KHz and 2.8 KHz, depending on conditions. Higher makes for easier copy, but lower will eliminate more noise, and help with nearby stations. Remember, the crystal filters are to protect the AtoD converter in the receiver. The DSP has many useful settings between those of the installed filters.
>>
>> 73 Bill AE6JV
>>
>> On 6/30/18 at 5:07 PM, 1lasportsman at cox.net (Bill) wrote:
>>
>>> I recently purchased a K3 and trying to set up for SSB.I do not do code.
>>> Is there any recommended settings for the shift lo cut and width?
>>> It has the KFL3A-400 and the KFL3A-12.8 8 pole filters installed
>>> I have read the manual and it does not really help me.
>>> Thanks
>>> Bill
>>> W3WGG
>>
>> ---------------------------------------------------------------------------
>> Bill Frantz        | Re: Computer reliability, performance, and security:
>> 408-356-8506       | The guy who *is* wearing a parachute is *not* the
>> www.pwpconsult.com | first to reach the ground.  - Terence Kelly
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to mjgillen at yahoo.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>