[Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

[Henrik Stenstrom]

Yes, I believe the baud rate is the problem.

Should be 38400.

de VK2HHS

On Fri, Feb 16, 2018 at 12:57 PM, Jack Brindle <jackbrindle at me.com> wrote:

> A little more info. The K3 and K3S default to 38400 bps on the serial
> port. This can be changed in the configuration menu, and you should verify
> the setting in the menu system.
> If it is still set to the default, set your PC for 38400 bps (and the
> MicroHam device as well, then give it a try. N1MM works very well with the
> K3, so it is a matter of getting the configuration correct to make it work.
>
> We 73!
>
> Jack, W6FB
>
>
> > On Feb 15, 2018, at 5:33 PM, Greg Best <gbconsulting54 at gmail.com> wrote:
> >
> > I am trying to get N1MM+ to talk to my K3 but will not do it.
> >
> > I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1.  DTR and DTS
> have
> > been tried with both Always ON and Always OFF but neither one works.
> >
> > I have tried the Radio reset command from N1MM+ with no luck.
> >
> > Can anyone help?
> > 73¹s
> > Greg
> >
> > 16100 Outlook Avenue
> > Stilwell, KS 66085
> > 816-792-2913
> >
> >
> >
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to jackbrindle at me.com
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to vk2hhs at gmail.com
>