[Elecraft] FIRST TIME HOOKUP OF N1MM+ TO K3 VIS MICROHAM USB INTERFACE III

[Rick Tavan]

You got good advice on baud rate. Also, it's wise always to confirm proper
operation with K3 Utility first. If it doesn't connect, chances are N1MM
won't, either. Utility marches through speeds until it finds one that
works. MM requires a specific speed setting.

73,

/Rick N6XI


Rick Tavan
Truckee, CA

On Thu, Feb 15, 2018 at 5:33 PM, Greg Best <gbconsulting54 at gmail.com> wrote:

> I am trying to get N1MM+ to talk to my K3 but will not do it.
>
> I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1.  DTR and DTS
> have
> been tried with both Always ON and Always OFF but neither one works.
>
> I have tried the Radio reset command from N1MM+ with no luck.
>
> Can anyone help?
> 73¹s
> Greg
>
> 16100 Outlook Avenue
> Stilwell, KS 66085
> 816-792-2913
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rtavan at gmail.com
>