[Elecraft] Problem saving PX3 configuration

[Dave Sublette]

I tried it at least three times and got the same results.  I guess I better call support.

Thanks Don,

Dave
> On Oct 16, 2017, at 8:51 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:
> 
> Dave,
> 
> Try it several more times to see if that error is just a 'glitch' or if it is a hard error.
> 
> If A hard error, contact support at elecraft.com and see if they might have any answers.
> 
> 73,
> Don W3FPR
> 
> On 10/16/2017 8:44 PM, Dave Sublette wrote:
>> I just went through the amplitude and phase adjustment to null out the opposite sideband response.  All went well.  I started the PX3 Utility and tried to save the configuration settings, per the suggestion in the manual.
>> About half way into the process (Green Bar about 50%) I get an error message that says:
>> “No Response To Read EEPROM Block”.
>> After I X off the block, the Green bar just sits there. It doesn’t appear to be advancing so I cancel.  Evidently, I cannot save the configuration.
>> I don’t see anything in the manual about this.  Dies anyone know anything about this?