[Elecraft] Problem saving PX3 configuration

[Don Wilhelm]

Dave,

Try it several more times to see if that error is just a 'glitch' or if 
it is a hard error.

If A hard error, contact support at elecraft.com and see if they might have 
any answers.

73,
Don W3FPR

On 10/16/2017 8:44 PM, Dave Sublette wrote:
> I just went through the amplitude and phase adjustment to null out the opposite sideband response.  All went well.  I started the PX3 Utility and tried to save the configuration settings, per the suggestion in the manual.
> 
> About half way into the process (Green Bar about 50%) I get an error message that says:
> 
> “No Response To Read EEPROM Block”.
> 
> After I X off the block, the Green bar just sits there. It doesn’t appear to be advancing so I cancel.  Evidently, I cannot save the configuration.
> 
> I don’t see anything in the manual about this.  Dies anyone know anything about this?