[Elecraft] Problem saving PX3 configuration

[Dave Sublette]

I just tried it again and got the same thing.  I was able to download and install firmware.  It was the same that was in the PX3 but at least the comm port is working.  

> On Oct 16, 2017, at 8:57 PM, Dave Sublette <k4to at arrl.net> wrote:
> 
> I tried it at least three times and got the same results.  I guess I better call support.
> 
> Thanks Don,
> 
> Dave
>> On Oct 16, 2017, at 8:51 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:
>> 
>> Dave,
>> 
>> Try it several more times to see if that error is just a 'glitch' or if it is a hard error.
>> 
>> If A hard error, contact support at elecraft.com and see if they might have any answers.
>> 
>> 73,
>> Don W3FPR
>> 
>> On 10/16/2017 8:44 PM, Dave Sublette wrote:
>>> I just went through the amplitude and phase adjustment to null out the opposite sideband response.  All went well.  I started the PX3 Utility and tried to save the configuration settings, per the suggestion in the manual.
>>> About half way into the process (Green Bar about 50%) I get an error message that says:
>>> “No Response To Read EEPROM Block”.
>>> After I X off the block, the Green bar just sits there. It doesn’t appear to be advancing so I cancel.  Evidently, I cannot save the configuration.
>>> I don’t see anything in the manual about this.  Dies anyone know anything about this?
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k4to at arrl.net