[Elecraft] K3S/P3-SVGA CW Decode - P3 Power Cycle

[MaverickNH]

Hi Tom - I was only using the K3 Utility to switch from one configuration to the other, then I close the port and close the program. But thanks for the heads up about not using them together. Bret/N4SRN


> On November 25, 2017 at 3:17 PM tomb18 <tomb18 at videotron.ca> wrote:
> 
>     Hi
>     Actually what is happening is that both the p3 svga and the utility are attempting to get access to the decoded text at the same time  so when one gets a character, the other misses it.. 
>     If you wish to use the utility, just turn off text decoding display on the svga. 
>     73 Tom 
> 
> 
> 
>     Sent from my Samsung Galaxy smartphone.
> 
>     -------- Original message --------
>     From: MaverickNH <cbjesseeNH at comcast.net>
>     Date: 2017-11-25 2:31 PM (GMT-05:00)
>     To: elecraft at mailman.qth.net
>     Subject: [Elecraft] K3S/P3-SVGA CW Decode - P3 Power Cycle
> 
>     I have always had problems using the K3 Utility to change configurations from
>     another mode to CW, as I could see text decode on the K3S VFO B display area
>     after a restore to my CW configuration but not on the P3-SVGA external
>     display without a lot of fiddling. I see now that simply turning the P3
>     on/off is required after a configuration restore to get that text decode to
>     display.
> 
>     I would make a note of that but would just forget where I put it. Now, it's
>     right here for me to find!
> 
>     Bret/N4SRN
> 
> 
> 
>     --
>     Sent from: http://elecraft.365791.n2.nabble.com/
>     ______________________________________________________________
>     Elecraft mailing list
>     Home: http://mailman.qth.net/mailman/listinfo/elecraft
>     Help: http://mailman.qth.net/mmfaq.htm
>     Post: mailto:Elecraft at mailman.qth.net
> 
>     This list hosted by: http://www.qsl.net
>     Please help support this email list: http://www.qsl.net/donate.html
>     Message delivered to tomb18 at videotron.ca
>