[Elecraft] K3S/P3-SVGA CW Decode - P3 Power Cycle

[tomb18]

HiActually what is happening is that both the p3 svga and the utility are attempting to get access to the decoded text at the same time  so when one gets a character, the other misses it.. If you wish to use the utility, just turn off text decoding display on the svga. 73 Tom 


Sent from my Samsung Galaxy smartphone.
-------- Original message --------From: MaverickNH <cbjesseeNH at comcast.net> Date: 2017-11-25  2:31 PM  (GMT-05:00) To: elecraft at mailman.qth.net Subject: [Elecraft] K3S/P3-SVGA CW Decode - P3 Power Cycle 
I have always had problems using the K3 Utility to change configurations from
another mode to CW, as I could see text decode on the K3S VFO B display area
after a restore to my CW configuration but not on the P3-SVGA external
display without a lot of fiddling. I see now that simply turning the P3
on/off is required after a configuration restore to get that text decode to
display.

I would make a note of that but would just forget where I put it. Now, it's
right here for me to find!

Bret/N4SRN



--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tomb18 at videotron.ca