[Elecraft] K3S CW Delay on KEY OUT ?

[Victor Rosenthal 4X6GP]

I forgot to add: and make sure the KEY OUT line is connected to the 
transverter, and the transverter is configured to use it. It seems like 
the transverter is sensing RF rather than using the K3S Key Out line.


73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
http://www.qsl.net/k2vco/

On 15 May 2017 16:58, Victor Rosenthal 4X6GP wrote:
> Make sure VOX is turned ON on the K3S.
>
> 73,
> Victor, 4X6GP
> Rehovot, Israel
> Formerly K2VCO
> http://www.qsl.net/k2vco/
>
> On 15 May 2017 16:20, Trevor Clapp wrote:
>> When I am using the K3S with an external transverter which uses the
>> key out line to change from RX to TX i am finding that with a paddle
>> input from my Winkeyer I cannot get the transverter to remain keyed.
>> Adjusting the CW delay does not increase the time btween keying and
>> the relay in the transverter clicking out.  So basically I get the
>> relay clicking on every keyed letter.
>>
>> I have dried full and semi break in with no difference.
>>
>> I do not have the same situation on the KX3 , but then I am not using
>> an external transverter, and wondered if there was another setting
>> somewhere that I should be looking at.
>>
>> 2EØLDZ Trevor Clapp M. 07900 49 77 11