[Elecraft] K3S CW Delay on KEY OUT ?

[Don Wilhelm]

Trevor,

Make sure VOX is turned on for CW mode.  See page 33 of the manual.  The 
Delay setting should control the amount of delay after each dit/dah or 
if long enough it will not drop out until a significant time after 
keying stops.

If your transverters use relays, I suggest that semi-breakin will work 
better.  If you need even more control for T/R switching the 
transveters, use PTT.

73,
Don W3FPR

On 5/15/2017 9:20 AM, Trevor Clapp wrote:
> When I am using the K3S with an external transverter which uses the key out line to change from RX to TX i am finding that with a paddle input from my Winkeyer I cannot get the transverter to remain keyed. Adjusting the CW delay does not increase the time btween keying and the relay in the transverter clicking out.  So basically I get the relay clicking on every keyed letter.
>