[Elecraft] K3S CW Delay on KEY OUT ?

[Victor Rosenthal 4X6GP]

Make sure VOX is turned ON on the K3S.

73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
http://www.qsl.net/k2vco/

On 15 May 2017 16:20, Trevor Clapp wrote:
> When I am using the K3S with an external transverter which uses the
> key out line to change from RX to TX i am finding that with a paddle
> input from my Winkeyer I cannot get the transverter to remain keyed.
> Adjusting the CW delay does not increase the time btween keying and
> the relay in the transverter clicking out.  So basically I get the
> relay clicking on every keyed letter.
>
> I have dried full and semi break in with no difference.
>
> I do not have the same situation on the KX3 , but then I am not using
> an external transverter, and wondered if there was another setting
> somewhere that I should be looking at.
>
> 2EØLDZ Trevor Clapp M. 07900 49 77 11