[Elecraft] K3S CW Delay on KEY OUT ?

[Trevor Clapp]

When I am using the K3S with an external transverter which uses the key out line to change from RX to TX i am finding that with a paddle input from my Winkeyer I cannot get the transverter to remain keyed. Adjusting the CW delay does not increase the time btween keying and the relay in the transverter clicking out.  So basically I get the relay clicking on every keyed letter.

I have dried full and semi break in with no difference.

I do not have the same situation on the KX3 , but then I am not using an external transverter, and wondered if there was another setting somewhere that I should be looking at.

2EØLDZ
Trevor Clapp
M. 07900 49 77 11