[Elecraft] Kenwood MC-50 Mic and K2

[Don Wilhelm]

Ken,

That will work OK -- BUT only if your K2 microphone configuration header 
is wired for either the Elecraft (without the bias resistor) or the 
Kenwood mic pinout.

If you built the K2, you should know how it is plugged, but if you 
bought it used, check it.

If the bias resistor is installed, lift the resistor lead off mic jack 
pin 1.

73,
Don W3FPR

On 1/3/2017 2:57 PM, ken mcmahon wrote:
> Hi everybody,
>
> Here is my plan, please check me:
>
> Using a hybrid cable that I made for my K3 9 years ago....
>
> 5 pin Kenwood 'B Connector' (per the MC-50 manual) to an 8 pin DIN
> connector (K2 connection).
>
> 1 - 1 AF
> 2 - 2 PTT
> 5 - 7 GND
>